HOME PAGE ©1998 Reckart Equipment Co. Site design by Citynet Reckart R848 Standard unit to have 1 side plates, 48" width opening for maximum cut of 8-1/2" thick material, 2 - 3 -7/16" mandrel bearings, 1 - 2 -15/1" pillow block bearings, 2 ball bearing saw collars through hand wheel for moveable saws, 4 - 6-1/2" inserted tooth feed rolls, 1-15/16" bearings, 1-set of safety fingers, 8-1/2" pressure rolls, hinged type gate for easy saw removal, 2 speed with reverse through speed reducer, 2- 5 HP motors, air lift on pressure rolls, 10' infeed table with 4 -6-1/2" rolls with 1=15/16" shaft and bearings LESS: Saws, motor and drive. Approximate weight: 9,000 lbs. Available Options Not Included Overhead motor mount with guard Air lift safety fingers Split pressure and bed rolls Powered outfeed pressure roll on cant side Air lift on both sides for pressure rolls Split feed rolls ADD for moveable saw assembly (less saws) Stationary saw collar Adjustable guide fence 0=6" 10' rear table with 4 standard rolls EXTRA: For each additional roll EXTRA: For each additional foot of frame EXTRA: For making live rear table Hub & spacers complete with tie bolts for 2 stationary saws EXTRA: For each additional spacer Powered fence 0-12" Air lift loading and crowding chain with reverse, 2 chain unit 3 Chain unit 4 Chain unit Air crowding roll (must have powered fence) Powered crowding roll EXTRA: 20' x 5" belt tailer and 20' X 16" belt tailer for cant side EXTRA: For hold down wheels (for 5" belt only) total of two wheels 5 HP hydraulic power source 5 HP independent drive for belt tailer R436    R642    R848    R848TA [ reckart edgers ] [ sawmill design ] [ custom fabrication ] [ logging equipment ] [ parts & supplies ] [ information request ] [ sawdust blowers ] [ links ] [ contact us ]